Like the old one, but does not mention which remotes are scanned.
I think this is less confusing, as it does not imply the remotes
were somehow accessed (which they are not; inaccessible remotes
can be scanned.)
* get/copy --auto: Transfer data even if it would exceed numcopies,
when preferred content settings want it.
* drop --auto: Fix dropping content when there are no preferred content
settings.
Converted several threads to run in the monad.
Added a lot of useful combinators for working with the monad.
Now the monad includes the name of the thread.
Some debugging messages are disabled pending converting other threads.
This was complicated quite a bit by needing to check numcopies. I optimised
that, so it only looks up numcopies once per file, no matter how many
remotes it checks to drop from. Although it did just occur to me that
it might be better to first check if it wants to drop content, and only
then check numcopies..
This avoids the expensive transfer scan relying on its list of remotes
to scan being accurate throughout, which it will not be when the user
pauses syncing to a remote.
I feel it's ok to queue transfers to *any* known remote, not just the ones
being scanned.
Note that there are still small races where after syncing to a remote is
paused, a transfer can be queued for it. Not just in the expensive transfer
scan, but in the cheap failed transfer scan, and elsewhere.
Both when queueing downloads, and uploads, consults the preferred content
settings.
I didn't make it check yet when requeing failed transfers or queuing
deferred downloads; dealing with the preferred content settings (or indeed,
other settings) changing while the assistant is running still needs work.
Currently only the web special remote is readonly, but it'd be possible to
also have readonly drives, or other remotes. These are handled in the
assistant by only downloading from them, and never trying to upload to
them.
The expensive transfer scan now scans a whole set of remotes in one pass.
So at startup, or when network comes up, it will run only once.
Note that this can result in transfers from/to higher cost remotes being
queued before other transfers of other content from/to lower cost remotes.
Before, low cost remotes were scanned first and all their transfers came
first. When multiple transfers are queued for a key, the lower cost ones
are still queued first. However, this could result in transfers from slow
remotes running for a long time while transfers of other data from faster
remotes waits.
I expect to make the transfer queue smarter about ordering
and/or make it allow multiple transfers at a time, which should eliminate
this annoyance. (Also, it was already possible to get into that situation,
for example if the network was up, lots of transfers from slow remotes
might be queued, and then a disk is mounted and its faster transfers have
to wait.)
Also note that this means I don't need to improve the code in
Assistant.Sync that currently checks if any of the reconnected remotes
have diverged, and if so, queues scans of all of them. That had been very
innefficient, but now doesn't matter.
The problem with using it here is that, if a removable drive is scanned
and gets disconnected during the scan, testing for all the files will
indicate it doesn't have them, and the scan is logged as completed
successfully, without necessary transfers being queued.
The fun part was making it move things from TransferQueue to currentTransfers
entirely atomically. Which will avoid inconsistent display if the WebApp
renders the current status at just the wrong time. STM to the rescue!
