When setting up a remote on a ssh server, prompt for a password inside the
webapp, rather than relying on ssh's own password prompting in the terminal
the webapp was started from, or ssh-askpass.
Avoids double prompting for the ssh password (and triple-prompting on
windows for rsync.net), since the entered password is cached for 10 minutes
and this cached password is reused when setting up the repository, after
the initial probe.
When the user has an existing ssh key set up, they can choose to use it,
rather than entering a password. The webapp used to probe for this case
automatically, so this is a little harder, but it's an advanced user thing.
Note that this commit is known to break enabling existing rsync
repositories. It hs not been tested with gcrypt repositories. It's not been
successfully tested yet on Windows.
This commit was sponsored by Ralph Mayer.
To use, set GIT_ANNEX_SSHASKPASS to point to a fifo or regular file
(FIFO is better, avoids touching disk or multiple readers) that contains
the password. Then set SSH_ASKPASS=git-annex, and when ssh runs it, it will
tell ssh the password.
This is not yet used..
This is a better approach to finding both when NM has lost a network
connection, and when a new network connection is made by NM.
Tested with network-manager 0.9.8.8.
This commit was sponsored by Cedric Staub.
* Remote system might be available, and connection get lost. Should
reconnect, but needs to avoid bad behavior (ie, constant reconnect
attempts.) Use exponential backoff.
* Detect if old system had a too old git-annex-shell, and show the user
a nice message in the webapp. Required parsing error messages, so perhaps
this code shoudl be removed once enough time has passed..
* Switch the protocol to using remote URI's, rather than remote names.
Names change. Also avoids issues with serialization of names containing
whitespace.
This is nearly ready for merge into master now. I'd still like to make the ssh
transport smarter about reusing ssh connection caching during git pull.
This commit was sponsored by Jim Paris.
a ssh remote, and pulls.
XMPP is no longer needed in this configuration!
Requires the remote server have git-annex-shell with notifychanges support.
(untested)
This commit was sponsored by Geog Wechslberger.
So far, handling connecting to git-annex-shell notifychanges, and
pulling immediately when a change is pushed to a remote.
A little bit buggy (crashes after the first pull), but it already works!
This commit was sponsored by Mark Sheppard.
This will be used by the remote-daemon to quickly tell when changes have
been pushed from some other repository into a ssh remote.
Adjusted the remote-daemon protocol to communicate changed shas, rather
than git branch refs. This way, it can easily check if a sha is new.
This commit was sponsored by Carlos Trijueque Albarran.
