The post-install depends on the -openrc files being present, and if the
dependency isn't explicitly specified then the device-* package may be
installed before the -openrc package, causing the post-install to fail.
Both sway and phosh require hardware acceleration (DRM) to work. Let's
activate that when we request one of them. Also don't let them fail
during startup on inputless setups (which is common on a raspberry pi).
Phosh is too slow to be unsable, but now, it'll at least be unusable out
of the box ;-)
Without this MR, elogind, and therefore weston will not start as it will
complain about cgroup mess:
[ 21.387150] elogind-daemon[1538]: Failed to determine whether /sys/fs/cgroup is a mount point: Symbolic link loop
[ 21.388341] elogind-daemon[1538]: Failed to mount cgroup at /sys/fs/cgroup/elogind: No such file or directory
Fix by applying this patch, thanks minlexx for pointing me to it! This
might possibly also be applicable to other kernel 3.4-based ports.
[ci:skip-build]: already built successfully in CI
This provides alsa usecase profiles for the audio routing in the
pinephone, pulseaudio also picks up this config.
[ci:skip-build]: already built successfully in CI
Remove all firmware-support dependencies from the firmware package and
add them to -downstream-firmware and -mainline-firmware packages which
have an install_if on the downstream or mainline kernel subpackage.
[ci:skip-build]: already built successfully in CI
Stock Android on PineTab is detected as 1f3a:1007.
Use those values as USB idVendor and idProduct on
postmarketOS, too.
idVendor 1f3a is "Allwinner Technology Co., Ltd."
idProduct 1007 is unknown to databases.
device/device-asus-me176c:
- Install me176c-factory to apply correct MAC addresses for
WiFi and BT
- Use FAT32 for boot partition. This allows flashing the boot
partition directly as ESP (EFI System Partition).
- Overall cleanup
device/linux-asus-me176c:
- Update kernel fork to 4.19.80
- Cleanup APKBUILD
- Stop building patched ACPI DSDT table directly into kernel
firmware/firmware-asus-me176c:
- Package WiFi firmware
firmware/firmware-asus-me176c-acpi:
- New package for the patched ACPI DSDT table
-> Separate from firmware-asus-me176c because it is always required,
(not optional)
[ci:skip-build]: runs into timeout
The modem boots up properly without causing any problems, so let's
install the firmware and support packages by default.
Also install adsp-audio now by default to boot up the adsp for audio and
other services provided by the processor.
[ci:skip-build]: already built successfully in CI
The initramfs needs ext4 (to mount the rootfs) and usb_f_rndis
(to enable USB networking on devices that use USB configfs).
If these are built as modules, they need to be included in initramfs.
[ci:skip-build]: already built successfully in CI
