All callers adjusted to update it themselves.
In Command.ReKey, and Command.SetKey, the cleanup action already did,
so it was updating the log twice before.
This fixes a bug when annex.stalldetection is set, as now
Command.Transferrer can skip updating the location log, and let it be
updated by the calling process.
This is to avoid breakage when upgrading or downgrading git-annex with a
process running that uses the interface. It's better to keep the
compatability code for a few years than worry about such breakage.
This commit was sponsored by Brett Eisenberg on Patreon.
New config annex.stalldetection, remote.name.annex-stalldetection, which
can be used to deal with remotes that stall during transfers, or are
sometimes too slow to want to use.
This commit was sponsored by Luke Shumaker on Patreon.
That seems to be the last thing needed for message serialization.
Although it's only used in the assistant currently, so hard to tell if I
forgot something.
At this point, it should be possible to start using transferkeys
when performing transfers, which will allow killing a transferkeys
process if a transfer times out or stalls. But that's for another day.
This commit was sponsored by Ethan Aubin.
Added annex.adjustedbranchrefresh git config to update adjusted branches
set up by git-annex adjust --unlock-present/--hide-missing.
Note, in a few cases, I was not able to make the adjusted branch
be updated in calls to moveAnnex, because information about what
file corresponds to a key is not available. They are:
* If two files point to one file, then eg, `git annex get foo` will
update the branch to unlock foo, but will not unlock bar, because it
does not know about it. Might be fixable by making `git annex get
bar` do something besides skipping bar?
* git-annex-shell recvkey likewise (so sends over ssh from old versions
of git-annex)
* git-annex setkey
* git-annex transferkey if the user does not use --file
* git-annex multicast sends keys with no associated file info
Doing a single full refresh at the end, after any incremental refresh,
will deal with those edge cases.
Note that, the way the SeekInput parser is written to support batch mode,
it's actually possible to do git-annex examinekey
"SHA1--foo foo.tar.gz" --migrate-to-backend=SHA1E
While that might be kind of useful to support multiple migrations not using
batch mode, I have not documented it. It would be better to take pairs of
key and file in that case.
In cases where numcopies checks prevented the resumed move from dropping
the object from the source repository, it now relies on a log of recent
moves to replicate the behavior of the interrupted command.
Performance: Probably noticable impact, since it has to add to the log,
check the log, and remove from the log. Seems worth it to avoid this
annoying edge case. The log functions are pretty well optimised to avoid
unncessary work.
An performance improvement to make later would be to avoid cleanup doing
anything if it's not written to the log file, and has confirmed that the
log file does not contain the log line.
This commit was sponsored by Jake Vosloo on Patreon.
The problem was this line:
cleanup = and <$> sequence (map snd v)
That caused all of v to be held onto until the end, when the cleanup action
was run.
I could not seem to find a bang pattern that avoided the leak, so I
resorted to a IORef, rather clunky, but not a performance problem because
it will only be written once per git ls-files, so typically just 1 time.
This commit was sponsored by Mark Reidenbach on Patreon.
