Added annex.bwlimit and remote.name.annex-bwlimit config that works for git
remotes and many but not all special remotes.
This nearly works, at least for a git remote on the same disk. With it set
to 100kb/1s, the meter displays an actual bandwidth of 128 kb/s, with
occasional spikes to 160 kb/s. So it needs to delay just a bit longer...
I'm unsure why.
However, at the beginning a lot of data flows before it determines the
right bandwidth limit. A granularity of less than 1s would probably improve
that.
And, I don't know yet if it makes sense to have it be 100ks/1s rather than
100kb/s. Is there a situation where the user would want a larger
granularity? Does granulatity need to be configurable at all? I only used that
format for the config really in order to reuse an existing parser.
This can't support for external special remotes, or for ones that
themselves shell out to an external command. (Well, it could, but it
would involve pausing and resuming the child process tree, which seems
very hard to implement and very strange besides.) There could also be some
built-in special remotes that it still doesn't work for, due to them not
having a progress meter whose displays blocks the bandwidth using thread.
But I don't think there are actually any that run a separate thread for
downloads than the thread that displays the progress meter.
Sponsored-by: Graham Spencer on Patreon
When annex.stalldetection is not enabled, and a likely stall is detected,
display a suggestion to enable it.
Note that the progress meter display is not taken down when displaying
the message, so it will display like this:
0% 8 B 0 B/s
Transfer seems to have stalled. To handle stalling transfers, configure annex.stalldetection
0% 10 B 0 B/s
Although of course if it's really stalled, it will never update
again after the message. Taking down the progress meter and starting
a new one doesn't seem too necessary given how unusual this is,
also this does help show the state it was at when it stalled.
Use of uninterruptibleCancel here is ok, the thread it's canceling
only does STM transactions and sleeps. The annex thread that gets
forked off is separate to avoid it being canceled, so that it
can be joined back at the end.
A module cycle required moving from dupState the precaching of the
remote list. Doing it at startConcurrency should cover all the cases
where the remote list is used in concurrent actions.
This commit was sponsored by Kevin Mueller on Patreon.
annex.stalldetection can now be set to "true" to make git-annex do
automatic stall detection when it detects a remote is updating its transfer
progress consistently enough.
This commit was sponsored by Luke Shumaker on Patreon.
New config annex.stalldetection, remote.name.annex-stalldetection, which
can be used to deal with remotes that stall during transfers, or are
sometimes too slow to want to use.
This commit was sponsored by Luke Shumaker on Patreon.
