Change --metadata comparisons < > <= and >= to fall back to lexicographical
comparisons when one or both values being compared are not numbers.
Sponsored-by: Erik Bjäreholt on Patreon
While ErrorBusy and other exceptions were caught and the write retried for
up to 10 seconds, it was still possible for git-annex to eventually
give up and error out without writing to the database. Now it will retry
as long as necessary.
This does mean that, if one git-annex process is suspended just as sqlite
has locked the database for writing, another git-annex that tries to write
it it might get stuck retrying forever. But, that could already happen when
opening the sqlite database, which retries forever on ErrorBusy. This is an
area where git-annex is known to not behave well, there's a todo about the
general case of it.
Sponsored-by: Dartmouth College's Datalad project
S3: Speed up importing from a large bucket when fileprefix= is set by only
asking for files under the prefix.
getBucket still returns the files with the prefix included, so the rest of
the fileprefix stripping still works unchanged.
Sponsored-by: Dartmouth College's DANDI project
It's hard to know what's a good default for this. But 1 mb seems way too
small, because it's very easy for a git pull or some similar operation
that we don't think of as using much space to use up 1 mb of space.
Most people would want to free up some space if a filesystem only had 100
mb free. But on a small VPS, it's probably not uncommon to have only 1 gb
free. So 1 gb is too large for annex.diskreserve.
While old 1 gb USB keys are around, it's unlikely that anyone is
relying on them to shuttle annex data around; it would be worth anyone's
time to upgrade to a 32 gb or larger cheap modern USB key ($5).
Sponsored-by: Kevin Mueller on Patreon
autoEnableSpecialRemotes runs a subprocess, and if the uuid for a git
remote has not been probed yet, that will do a http get that will prompt
for a password. And then the parent process will subsequently prompt
for a password when getting annexed files from the remote.
So the solution is for autoEnableSpecialRemotes to run remoteList before
the subprocess, which will probe for the uuid for the git remote in the
same process that will later be used to get annexed files.
But, Remote.Git imports Annex.Init, and Remote.List imports Remote.Git,
so Annex.Init cannot import Remote.List. Had to pass remoteList into
functions in Annex.Init to get around this dependency loop.
When accessing a git remote over http needs a git credential prompt for a
password, cache it for the lifetime of the git-annex process, rather than
repeatedly prompting.
The git-lfs special remote already caches the credential when discovering
the endpoint. And presumably commands like git pull do as well, since they
may download multiple urls from a remote.
The TMVar CredentialCache is read, so two concurrent calls to
getBasicAuthFromCredential will both prompt for a credential.
There would already be two concurrent password prompts in such a case,
and existing uses of `prompt` probably avoid it. Anyway, it's no worse
than before.
