Split out two new commands, git-annex pull and git-annex push. Those plus a
git commit are equivilant to git-annex sync.
In a sense, git-annex sync conflates 3 things, and it would have been
better to have push and pull from the beginning and not sync. Although
note that git-annex sync --content is faster than a pull followed by a
push, because it only has to walk the tree once, look at preferred
content once, etc. So there is some value in git-annex sync in speed, as
well as user convenience.
And it would be hard to split out pull and push from sync, as far as the
implementaton goes. The implementation inside sync was easy, just adjust
SyncOptions so it does the right thing.
Note that the new commands default to syncing content, unless
annex.synccontent is explicitly set to false. I'd like sync to also do
that, but that's a hard transition to make. As a start to that
transition, I added a note to git-annex-sync.mdwn that it may start to
do so in a future version of git-annex. But a real transition would
necessarily involve displaying warnings when sync is used without
--content, and time.
Sponsored-by: Kevin Mueller on Patreon
Seems unlikely to be very useful, but trivial.
And, this completes the story that git-annex sync does not need json,
since every sub-operation is available in a command that does support json.
(Well, except for committing, but that's not a git-annex command.)
Sponsored-By: the NIH-funded NICEMAN (ReproNim TR&D3) project
Which is the same as the git merge option.
After last commit, this turns out to be needed in the test suite, and when
doing git-annex import from special remote, followed by a git-annex merge.
Sponsored-by: Svenne Krap on Patreon
Sometimes users would get confused because an option they were looking
for was not mentioned on a subcommand's man page, and they had not
noticed that the main git-annex man page had a list of common options.
This change lets each subcommand mention the common options, similarly
to how the matching options are handled.
This commit was sponsored by Svenne Krap on Patreon.
* merge: When run with a branch parameter, merges from that branch.
This is especially useful when using an adjusted branch, because
it applies the same adjustment to the branch before merging it.
* Added annex.resolvemerge configuration, which can be set to false to
disable the usual automatic merge conflict resolution done by git-annex
sync and the assistant.
* sync: Added --no-resolvemerge option.
Note that disabling merge conflict resolution is probably not a good idea
in a direct mode repo or adjusted branch. Since updates to both are done
outside the usual work tree, if it fails the tree is not left in a
conflicted state, and it would be hard to manually resolve the conflict.
Still, made annex.resolvemerge be supported in those cases for consistency.
This commit was sponsored by Riku Voipio.
i found that most man pages only had references to the main git-annex
manpage, which i stillfind pretty huge and hard to navigate through.
i tried to sift through all the man pages and add cross-references
between relevant pages. my general rule of thumb is that links should
be both ways unless one of the pages is a more general page that would
become ridiculously huge if all backlinks would be added
(git-annex-preferred-content comes to mind).
i have also make the links one per line as this is how it was done in
the metadata pages so far.
i did everything but the plumbing, utility and test commands, although
some of those are linked from the other commands so cross-links were
added there as well.
