* Prevent interactive warning to pop once already approved when
[over/down]clocking DRAM
* Make sure $freq is always set
Co-Authored-By: Oliver Smith <ollieparanoid@postmarketos.org>
In 35f283a8ef sxmo was made to install
sxmo on clean installs, but due to
9387842aec was getting uninstalled if it
was installed before. Let's properly depend on it instead so people
don't end up without working networking
Gummiboot was dropped from Alpine. Switch to grub, which is what we use
for tablet-x86uefi too.
In contrary to tablet-x86uefi, run the grub-mkimage command directly
inside the device package:
* This avoids creating another confusing grub-x86 like package (looks
like the x86 version of alpine's grub package, as it's the case with
grub-efi-x86, but actually it is just the result of grub-mkimage).
* In contrary to grub-efi-x86, the resulting efi file is not shared
across several devices.
* It's consistent with uboot mkimage commands, which we also run in
device packages.
Related: 398b7aef0b
The Mer stack that Asteroid uses actually uses connman by default rather
than NetworkManager, so let's enable it by default
SSH still works at least on Qemu
The Mer stack that Glacier uses actually uses connman by default rather
than NetworkManager, so let's enable it by default
SSH still works at least on Qemu
The v5.12.5-msm8996 tag also includes the yet-to-be-merged Qualcomm LPG
driver, with support for LEDs on xiaomi-scorpio including the IR LED.
Also clean up the config and enable useful configs such as ZRAM.
[ci:skip-build]: already built successfully in CI
We've rename the kernel repo to
https://gitlab.com/sdm845-mainline/linux,
update the package to point to the new repo.
[ci:skip-build]: already built successfully in CI
We used to have it at 40% and just bumped it to 100%. With 100%, I can
hear static noise in the headphones when using the PinePhone (pmOS CE)
in a silent room, even if I turn the volume down in Pulseaudio (e.g.
18%-30% in Phosh). This was not the case when we had it at 40%.
70% seems to be the sweet spot, where no static noise can be heard when
using headphones in a silent room, but where volume can still be turned
up to a very high level if necessary.
Ported succesfully to armv7. Everything that worked on armhf
works on armv7 as well: touch, wifi, usb networking etc.
SWRast (gallium) was not enabled but is needed because the device
does not support 3D acceleration yet.