It would be nice if command-specific options were supported. The first
difficulty is that which command is being called is not known until after
getopt; but that could be worked around by finding the first non-dashed
parameter. Storing the settings without putting them in the annex monad is
the next difficulty; it could perhaps be handled by making the seek stage
pass applicable settings into the start stage (and from there on to perform
as needed). But that still leaves a problem, what data type to use to
represent the options between getopt and seek?
Using Sets is the right thing; they have constant size lookup like my
SizeList, and logn insertation, which beats nub to death.
Runs faster than --fast mode did before, and gives accurate counts.
13 seconds total runtime with a warm cache in a repository with 40 thousand
keys.
find: Rather than only showing files whose contents are present, when used
with --exclude --copies or --in, displays all files that match the
specified conditions.
Note that this is a behavior change for find --exclude! Old behavior
can be gotten with find --in . --exclude=...
get, drop: Added --auto option, which decides whether to get/drop content
as needed to work toward the configured numcopies.
The problem with bundling it up in optimize was that I then found I wanted
to run an optmize that did not drop files, only got them. Considered adding
a --only-get switch to it, but that seemed wrong. Instead, let's make
existing subcommands optionally smarter.
Note that the only actual difference between drop and drop --auto is that
the latter does not even try to drop a file if it knows of not enough
copies, and does not print any error messages about files it was unable to
drop.
It might be nice to make get avoid asking git for attributes when not in
auto mode. For now it always asks for attributes.
This includes a generic JSONStream library built on top of Text.JSON
(somewhat hackishly).
It would be possible to stream out a single json document describing
all actions, but it's probably better for consumers if they can expect
one json document per line, so I did it that way instead.
Output from external programs used for transferring files is not
currently hidden when outputting json, which probably makes it not very
useful there. This may be dealt with if there is demand for json
output for --get or --move to be parsable.
The version, status, and find subcommands have hand-crafted output and
don't do json. The whereis subcommand needs to be modified to produce
useful json.
