* config: Added the --show-origin and --for-file options.
* config: Support annex.numcopies and annex.mincopies.
There is a little bit of redundancy here with other code elsewhere that
combines the various configs and selects which to use. But really only
for the special case of annex.numcopies, which is a git config that does
not override the annex branch setting and for annex.mincopies, which does
not have a git config but does have gitattributes settings as well as the
annex branch setting.
That seems small enough, and unlikely enough to grow into a mess that it was
worth supporting annex.numcopies and annex.mincopies in git-annex config
--show-origin. Because these settings are a prime thing that someone might
get confused about and want to know where they were configured.
And, it followed that git-annex config might as well support those two
for --set and --get as well. While this is redundant with the speclialized
commands, it's only a little code and it makes it more consistent.
Note that --set does not have as nice output as numcopies/mincopies
commands in some special cases like setting to 0 or a negative number.
It does avoid setting to a bad value thanks to the smart
constructors (eg configuredNumCopies).
As for other git-annex branch configurations that are not set by git-annex
config, things like trust and wanted that are specific to a repository
don't map to a git config name, so don't really fit into git-annex config.
And they are only configured in the git-annex branch with no local override
(at least so far), so --show-origin would not be useful for them.
Sponsored-by: Dartmouth College's DANDI project
Sometimes users would get confused because an option they were looking
for was not mentioned on a subcommand's man page, and they had not
noticed that the main git-annex man page had a list of common options.
This change lets each subcommand mention the common options, similarly
to how the matching options are handled.
This commit was sponsored by Svenne Krap on Patreon.
I had been assuming that numcopies would be a larger or at most equal to
mincopies, so no need to check both. But users get confused and use configs
that don't really make sense, so make sure to handle mincopies being larger
than numcopies.
Also add something to the mincopies man page to discourage this
misconfiguration.
This commit was sponsored by Denis Dzyubenko on Patreon.
This is conceptually very simple, just making a 1 that was hard coded be
exposed as a config option. The hard part was plumbing all that, and
dealing with complexities like reading it from git attributes at the
same time that numcopies is read.
Behavior change: When numcopies is set to 0, git-annex used to drop
content without requiring any copies. Now to get that (highly unsafe)
behavior, mincopies also needs to be set to 0. It seemed better to
remove that edge case, than complicate mincopies by ignoring it when
numcopies is 0.
This commit was sponsored by Denis Dzyubenko on Patreon.
