Make sanity checker run git annex unused daily, and queue up transfers
of unused files to any remotes that will have them. The transfer retrying
code works for us here, so eg when a backup disk remote is plugged in,
any transfers to it are done. Once the unused files reach a remote,
they'll be removed locally as unwanted.
If the setup does not cause unused files to go to a remote, they'll pile
up, and the sanity checker detects this using some heuristics that are
pretty good -- 1000 unused files, or 10% of disk used by unused files,
or more disk wasted by unused files than is left free. Once it detects
this, it pops up an alert in the webapp, with a button to take action.
TODO: Webapp UI to configure this, and also the ability to launch an
immediate cleanup of all unused files.
This commit was sponsored by Simon Michael.
Checking .gitattributes adds a full minute to a git annex find looking for
files that don't have enough copies. 2:25 increasts to 3:27. I feel this is
too much of a slowdown to justify making it the default. So, exposed two
versions of the preferred content expression, a slow one and a fast but
approximate one.
I'm using the approximate one in the default preferred content expressions
to avoid slowing down the assistant.
* Add numcopiesneeded preferred content expression.
* Client, transfer, incremental backup, and archive repositories
now want to get content that does not yet have enough copies.
This means the asssistant will make copies of files that don't yet
meet the configured numcopies, even to places that would not normally want
the file.
For example, if numcopies is 4, and there are 2 client repos and
2 transfer repos, and 2 removable backup drives, the file will be sent
to both transfer repos in order to make 4 copies. Once a removable drive
get a copy of the file, it will be dropped from one transfer repo or the
other (but not both).
Another example, numcopies is 3 and there is a client that has a backup
removable drive and two small archive repos. Normally once one of the small
archives has a file, it will not be put into the other one. But, to satisfy
numcopies, the assistant will duplicate it into the other small archive
too, if the backup repo is not available to receive the file.
I notice that these examples are fairly unlikely setups .. the old behavior
was not too bad, but it's nice to finally have it really correct.
.. Almost. I have skipped checking the annex.numcopies .gitattributes
out of fear it will be too slow.
This commit was sponsored by Florian Schlegel.
* numcopies: New command, sets global numcopies value that is seen by all
clones of a repository.
* The annex.numcopies git config setting is deprecated. Once the numcopies
command is used to set the global number of copies, any annex.numcopies
git configs will be ignored.
* assistant: Make the prefs page set the global numcopies.
This global numcopies setting is needed to let preferred content
expressions operate on numcopies.
It's also convenient, because typically if you want git-annex to preserve N
copies of files in a repo, you want it to do that no matter which repo it's
running in. Making it global avoids needing to warn the user about gotchas
involving inconsistent annex.numcopies settings.
(See changes to doc/numcopies.mdwn.)
Added a new variety of git-annex branch log file, that holds only 1 value.
Will probably be useful for other stuff later.
This commit was sponsored by Nicolas Pouillard.
