This is groundwork for nested seek loops, eg seeking over all files and
then performing commandActions on a list of remotes, which can be done
concurrently.
This commit was sponsored by Boyd Stephen Smith Jr. on Patreon.
Added to change notification to P2P protocol.
Switched to a TBChan so that a single long-running thread can be
started, and serve perhaps intermittent requests for change
notifications, without buffering all changes in memory.
The P2P runner currently starts up a new thread each times it waits
for a change, but that should allow later reusing a thread. Although
each connection from a peer will still need a new watcher thread to run.
The dependency on stm-chans is more or less free; some stuff in yesod
uses it, so it was already indirectly pulled in when building with the
webapp.
This commit was sponsored by Francois Marier on Patreon.
The attacker could just send a very lot of data, with no \n and it would
all be buffered in memory until the kernel killed git-annex or perhaps OOM
killed some other more valuable process.
This is a low impact security hole, only affecting communication between
local git-annex and git-annex-shell on the remote system. (With either
able to be the attacker). Only those with the right ssh key can do it. And,
there are probably lots of ways to construct git repositories that make git
use a lot of memory in various ways, which would have similar impact as
this attack.
The fix in P2P/IO.hs would have been higher impact, if it had made it to a
released version, since it would have allowed DOSing the tor hidden
service without needing to authenticate.
(The LockContent and NotifyChanges instances may not be really
exploitable; since the line is read and ignored, it probably gets read
lazily and does not end up staying buffered in memory.)
This is a work in progress. It compiles and is able to do basic command
dispatch, including git autocorrection, while using optparse-applicative
for the core commandline parsing.
* Many commands are temporarily disabled before conversion.
* Options are not wired in yet.
* cmdnorepo actions don't work yet.
Also, removed the [Command] list, which was only used in one place.
So far, handling connecting to git-annex-shell notifychanges, and
pulling immediately when a change is pushed to a remote.
A little bit buggy (crashes after the first pull), but it already works!
This commit was sponsored by Mark Sheppard.
This will be used by the remote-daemon to quickly tell when changes have
been pushed from some other repository into a ssh remote.
Adjusted the remote-daemon protocol to communicate changed shas, rather
than git branch refs. This way, it can easily check if a sha is new.
This commit was sponsored by Carlos Trijueque Albarran.
