ghc 8.0.2 may make this unncessary, but it's not in a stackage version yet,
so put in a workaround.
Note that the linux builds already delete the RPATHs for similar reasons.
This commit was sponsored by Josh Taylor on Patreon.
When used with an older version of ssh, any ServerAliveInterval in
~/.ssh/config will be overridden by .git/annex/ssh.config.
This commit was sponsored by Josh Taylor on Patreon.
The Makefile was putting them in git-annex.linux/i18n/i18n, and so I18NPATH
did not point to the files. I think that on close enough to Debian systems,
localedef then fell back to using the system-wide locale files, while on
other systems it would fail to generate locales.
So that stalled transfers will be noticed within about 3 minutes,
even if TCPKeepAlive is disabled or doesn't work.
Rather than setting with -o, use -F with another config file,
so that any settings in ~/.ssh/config or /etc/ssh/ssh_config overrides this.
If a transfer fails for some reason, but some data managed to be sent, the
transfer will be retried. (The assistant already did this.)
Possible impacts:
* More ssh prompts if ssh needs to prompt for a password to connect to a
host, or is prompting about some other problem like a ssh key mismatch.
* More data transfer due to retrying, epecially when a remote does not
support resuming a transfer.
In the worst case, a lot of data will be transferred but it fails before
the end, and then all that data gets transferred again plus one byte more;
repeat until it manages to get the whole file.
