The subtle part of this is what happens when the remote fails to remove
an empty directory. The removal from the export needs to fail in that
case, so the removal will be tried again later. However, removeExportLocation
has already been run and changed the export db, so if the next run
checks getExportLocation, it might decide nothing remains to be done,
leaving the empty directory.
Dealt with that by making removeEmptyDirectories, handle a failure
by calling addExportLocation, reverting the database changes so the next
run will be guaranteed to try deleting the empty directory again.
This commit was sponsored by Thomas Hochstein on Patreon.
Not yet called by Command.Export.
WebDAV needs this to clean up empty collections. Also, example.sh turned
out to not be cleaning up directories when removing content
from them, so it made sense for it to use this.
Remote.Directory did not need it, and since its cleanup method for empty
directories is more efficient than what Command.Export will need to do
to find empty directories, it uses Nothing so that extra work can be
avoided.
This commit was sponsored by Thom May on Patreon.
Don't allow "exporttree=yes" to be set when the special remote
does not support exports. That would be confusing since the user would
set up a special remote for exports, but `git annex export` to it would
later fail.
This commit was supported by the NSF-funded DataLad project.
Straightforward enough, except for the needed belt-and-suspenders sanity
checks to avoid foot shooting due to exports not being key/value stores.
* Even when annex.verify=false, always verify from exports.
* Only get files from exports that use a backend that supports
checksum verification.
* Never trust exports, even if the user says to, because then
`git annex drop` would drop content if the export seemed to contain
a copy.
This commit was supported by the NSF-funded DataLad project.
* Only export to remotes that were initialized to support it.
* Prevent storing key/value on export remotes.
* Prevent enabling exporttree=yes and encryption in the same remote.
SetupStage Enable was changed to take the old RemoteConfig.
This allowed only setting exporttree when initially setting up a
remote, and not configuring it later after stuff might already be stored
in the remote.
Went with =yes rather than =true for consistency with other parts of
git-annex. Changed docs accordingly.
This commit was supported by the NSF-funded DataLad project.
This will allow disabling exports for remotes that are not configured to
allow them. Also, exportSupported will be useful for the external
special remote to probe.
This commit was supported by the NSF-funded DataLad project
