And for tab completion, by not unnessessarily statting paths to remotes,
which used to cause eg, spin-up of removable drives.
Got rid of the remotes member of Git.Repo. This was a bit painful.
Remote.Git modifies the list of remotes as it reads their configs,
so still need a persistent list of remotes. So, put it in as
Annex.gitremotes. It's only populated by getGitRemotes, so commands
like examinekey that don't care about remotes won't do so.
This commit was sponsored by Jake Vosloo on Patreon.
Added remote configuration settings annex-ignore-command and
annex-sync-command, which are dynamic equivilants of the annex-ignore
and annex-sync configurations.
For this I needed a new DynamicConfig infrastructure. Its implementation
should be as fast as before when there is no dynamic config, and it caches
so shell commands are only run once.
Note that annex-ignore-command exits nonzero when the remote should be ignored.
While that may seem backwards, it allows using the same command for it as
for annex-sync-command when you want to disable both.
This commit was sponsored by Trenton Cronholm on Patreon.
* sync: Use the ssh-options git config when doing git pull and push.
* remotedaemon: Use the ssh-options git config.
Note that the rename env var means that if a new git-annex calls an old one
for git-annex ssh, or a new calls an old, nothing much will go wrong;
just ssh caching won't happen.
* Remote system might be available, and connection get lost. Should
reconnect, but needs to avoid bad behavior (ie, constant reconnect
attempts.) Use exponential backoff.
* Detect if old system had a too old git-annex-shell, and show the user
a nice message in the webapp. Required parsing error messages, so perhaps
this code shoudl be removed once enough time has passed..
* Switch the protocol to using remote URI's, rather than remote names.
Names change. Also avoids issues with serialization of names containing
whitespace.
This is nearly ready for merge into master now. I'd still like to make the ssh
transport smarter about reusing ssh connection caching during git pull.
This commit was sponsored by Jim Paris.
So far, handling connecting to git-annex-shell notifychanges, and
pulling immediately when a change is pushed to a remote.
A little bit buggy (crashes after the first pull), but it already works!
This commit was sponsored by Mark Sheppard.
