The former can be useful to make remotes that don't get fully synced with
local changes, which comes up in a lot of situations.
The latter was mostly added for symmetry, but could be useful (though less
likely to be).
Implementing `remote.<name>.annex-pull` was a bit tricky, as there's no one
place where git-annex pulls/fetches from remotes. I audited all
instances of "fetch" and "pull". A few cases were left not checking this
config:
* Git.Repair can try to pull missing refs from a remote, and if the local
repo is corrupted, that seems a reasonable thing to do even though
the config would normally prevent it.
* Assistant.WebApp.Gpg and Remote.Gcrypt and Remote.Git do fetches
as part of the setup process of a remote. The config would probably not
be set then, and having the setup fail seems worse than honoring it if it
is already set.
I have not prevented all the code that does a "merge" from merging branches
from remotes with remote.<name>.annex-pull=false. That could perhaps
be done, but it would need a way to map from branch name to remote name,
and the way refspecs work makes that hard to get really correct. So if the
user fetches manually, the git-annex branch will get merged, for example.
Anther way of looking at/justifying this is that the setting is called
"annex-pull", not "annex-merge".
This commit was supported by the NSF-funded DataLad project.
For sync, saves 1 ssh connection per remote. For remotedaemon, the same
ssh connection that is already open to run git-annex-shell notifychanges
is reused to pull from the remote.
Only potential problem is that this also enables connection caching
when the assistant syncs with a ssh remote. Including the sync it does
when a network connection has just come up. In that case, cached ssh
connections are likely to be stale, and so using them would hang.
Until I'm sure such problems have been dealt with, this commit needs to
stay on the remotecontrol branch, and not be merged to master.
This commit was sponsored by Alexandre Dupas.
