The Makefile was putting them in git-annex.linux/i18n/i18n, and so I18NPATH
did not point to the files. I think that on close enough to Debian systems,
localedef then fell back to using the system-wide locale files, while on
other systems it would fail to generate locales.
So that stalled transfers will be noticed within about 3 minutes,
even if TCPKeepAlive is disabled or doesn't work.
Rather than setting with -o, use -F with another config file,
so that any settings in ~/.ssh/config or /etc/ssh/ssh_config overrides this.
If a transfer fails for some reason, but some data managed to be sent, the
transfer will be retried. (The assistant already did this.)
Possible impacts:
* More ssh prompts if ssh needs to prompt for a password to connect to a
host, or is prompting about some other problem like a ssh key mismatch.
* More data transfer due to retrying, epecially when a remote does not
support resuming a transfer.
In the worst case, a lot of data will be transferred but it fails before
the end, and then all that data gets transferred again plus one byte more;
repeat until it manages to get the whole file.
Closes https://github.com/datalad/datalad/issues/1020
The use of runWriter in scanUnlockedFiles broke due to this change;
it failed with blocked indefinitely in mvar, because the database write
handle was taken while linkFromAnnex needed to also write to it (to update
the inode cache). So, switched to using a separate runWriter for each call
to addAssociatedFileFast. A little less efficient, but not greatly; the
writes should all still be cached.
