Make these features solely dependent on the OS being built on.
This lets stack build on windows w/o XMPP, on OSX w/o DBUS,
and on Linux with everything.
Since stack is being used to build the OSX autouild now, I want xmpp
enabled.
This means stack can't be used to build git-annex on windows, unless the
user edits this file and disables xmpp. Unfortunate that stack is so
unconfigurable, compared with cabal..
Now available on mips, mipsel, but temporarily removed armel since build is
failing there.
If armel would just get caught up, I could remove the per-arch specs
entirely.
Maybe time to turn maint of this over to richih?
Decided it's too scary to make v6 unlocked files have 1 copy by default,
but that should be available to those who need it. This is consistent with
git-annex not dropping unused content without --force, etc.
* Added annex.thin setting, which makes unlocked files in v6 repositories
be hard linked to their content, instead of a copy. This saves disk
space but means any modification of an unlocked file will lose the local
(and possibly only) copy of the old version.
* Enable annex.thin by default on upgrade from direct mode to v6, since
direct mode made the same tradeoff.
* fix: Adjusts unlocked files as configured by annex.thin.
This optimisation was not necessary, and didn't work for v6 unlocked files.
Typically only a small number of files will be changed by a commit, so just
catKey them all.
In copyFromRemote, it used to check isDirect, but that was not needed;
the remote is sending the file, so it doesn't matter if the local,
receiving repository is in direct mode or not. And, since the content is not
present, yet, it's certianly not unlocked. Note that, the remote may indeed
be sending an unlocked file, but sendkey uses sendAnnex, which will detect
if the file is modified before or during transfer, and will exit nonzero,
aborting the upload. So, the receiver doesn't need any checks.
In copyToRemote, it forces recvkey to verify content whenever it's being
sent from a v6 repository. recvkey is almost always going to verify content
anyway, unless annex.verify is not set. So, this doesn't make it any more
expensive, except for in that unusual configuration. The alternative would
be to change the recvkey interface, so that the sender checks afterwards if
what it was sending changed, and the receiver then throws out the bad
transfer. That would be less expensive for the reciever, as it would not
need to do a checksum verification. But, it would mean another network
round trip, and since rsync closes the connection, it would need to open
another ssh connection to do this. Even with connction caching, that would
add latency to uploads. It would also complicate the interface, especially
because an older git-annex-shell would not have the new interface
available. For these reasons, I prefer punting on that at this time, and
instead someone might set annex.verify=false and be unhappy that it still
verifies..
(One other gotcha not dealt with is that a v5 repo could be upgraded to v6
while an upload is in progress, and a file unlocked and modified.)
(Also, I double-checked Remote.GCrypt's calls to rsyncParamsRemote, and
they're fine. When a file is being uploaded to gcrypt, or any other special
repository, it is mediated by sendAnnex, so changes will be detected at
that level and the special remote implementation doesn't need to worry
about them.)
The direct flag is also set when sending unlocked content, to support old
versions of git-annex-shell. At some point, the direct flag will be
removed, and only the unlocked flag will be used.
