v6: When annex.largefiles is not configured for a file, running git add or
git commit, or otherwise using git to stage a file will add it to the annex
if the file was in the annex before, and to git otherwise. This is to avoid
accidental conversion.
Note that git-annex add's behavior has not changed, for reasons explained
in the added comment.
Performance: No added overhead when annex.largefiles is configured.
When not configured, there is an added call to catObjectMetaData,
which involves a round trip through git cat-file --batch.
However, the earlier catKeyFile primes the cache for it.
This commit was supported by the NSF-funded DataLad project.
Last of the known v6 races.
This also makes git add of a pointer file populate it when its content
is present in the annex. Which makes sense to do, I think.
This commit was supported by the NSF-funded DataLad project.
Update pointer file next time reconcileStaged is run to recover from the
race.
Note that restagePointerFile causes git to run the clean filter,
and that will run reconcileStaged. So, normally by the time the git
annex get/drop command finishes, the race has already been dealt with.
It may be that, in some case, that won't happen and the race will be
dealt with at a later point. git-annex could run reconcileStaged at
shutdown if that becomes a problem.
This does not handle the situation where the git mv is committed before
git-annex gets a chance to run again. git commit does run the clean
filter, and that happens to re-inject the content if it was supposed to
be dropped but is still populated. But, the case where the file was
supposed to be gotten but is not populated is not handled yet.
This commit was supported by the NSF-funded DataLad project.
