e129e3ddb0
- Cleanup kernel cmdline:
- earlycon can automatically detect the memory address of
the UART controller based on the device tree
- the comma before n8 in console=ttyMSM0,115200,n8 is actually
invalid so this was not parsed correctly. However, it is the
default anyway so we might as well remove it completely
- Configure deviceinfo_getty for all devices
- Workaround probe issue of display by adding a softdep on the panel
module. This allows the display to work when excluding proprietary
firmware (just a weird side effect, see comment in modprobe.conf...)
20 lines
1 KiB
Text
20 lines
1 KiB
Text
#
|
|
# There is a weird probe issue if both MSM DRM and the panel driver are built
|
|
# as modules: When MSM DRM is loaded it registers the DSI bus for the panel.
|
|
# At this point the panel is not loaded yet, so the kernel sends an uevent
|
|
# to userspace to load the necessary panel module.
|
|
#
|
|
# This causes some delay until the panel module is loaded, so MSM DRM fails to
|
|
# probe temporarily and returns -EPROBE_DEFER (to request probing again later).
|
|
# Unfortunately this will also unregister the DSI bus for the panel, and the
|
|
# kernel will not try probing MSM DRM + panel again until some other (slow)
|
|
# driver loads after MSM DRM.
|
|
#
|
|
# Usually WCNSS (WiFi/BT) fits that criteria, allowing the display to work.
|
|
# But this does not work if the user decides to exclude proprietary firmware.
|
|
#
|
|
# To avoid this problem we add an explicit soft dependency for MSM DRM
|
|
# on the panel module, so modprobe loads the panel module first and MSM DRM
|
|
# will immediately find the panel it is looking for.
|
|
#
|
|
softdep msm pre: panel-samsung-s6d7aa0-ltl101at01
|