This device port uses U-Boot as a basic bootloader. Users should install
U-Boot and reinstall pmOS to the U-Boot version of port (this one).
Thus an upgrade from old installations that depend on old vendor bootloader
is not implemented.
Instruction how to install U-Boot can be found on dedicated page of
pmOS wiki.
Signed-off-by: Svyatoslav Ryhel <clamor95@gmail.com>
Logging is important, we want our users to have logging, so make sure we
enable the new logbookd service on existing installation.
We check that we're upgrading from a postmarketos-base version that
predates logbookd and only enable the service in this case. This way we
won't enable it again for folks who disabled it manually.
Signed-off-by: Caleb Connolly <caleb@connolly.tech>
[ci:skip-vercheck]
Use logbookd to replace the busybox in-memory logger. The default
configuration of logbookd still logs in-memory but writes out the log on
shutdown or manual trigger.
The logread command is also replaced by a drop-in replacement for the
busybox tool.
In order to get stable WiFi and Bluetooth MAC addresses, install the
bootmac service by default.
Also as noted in other device package reviews, qbootctl-openrc should be
a dependency so the post-install/post-upgrade script will definitely
have the openrc service available.
[ci:skip-build]: already built successfully in CI
Also disable some drivers and subsystems in the kernel configuration
that are generally unused on the platform, according to the
corresponding patch in the kernel repository.
[ci:skip-build]: already built successfully in CI
Drop all the non-sdm845 DTBs. This saves about 12MiB
of space in /boot
Signed-off-by: Caleb Connolly <caleb@connolly.tech>
[ci:skip-build]: already built successfully in CI
The post-upgrade script in pmos-base isn't symlinked to the post-install
script, so zram-init wasn't being enabled on systems that upgraded to
the pmos-base version that intro'd this feature. I think this should
have been enabled by default on upgraded systems. There's a deviceinfo
toggle for it, so users who won't want to use this can set that var to
disable it, in that case having the service enabled is basically a
no-op.
Update by Oliver: add a comment to mention the deviceinfo variable
[ci:skip-build]: already built successfully in CI
[ci:skip-vercheck] no feature changes
Signed-off-by: Ferass El Hafidi <vitali64pmemail@protonmail.com>
[ci:skip-build]: already built successfully in CI
This was a fallout from the /usr/share relocation, only found and
reported now by z3ntu. If the device package happened to be installed
later, then the link would point to the wrong location.
Fixes 1d748a93dd
Allows things like podman/docker to work out of the box.
I looked at /etc/init.d/cgroups, and having this service enabled isn't a
problem if the kernel doesn't have cgroup support... in that situation,
the service script just simply exits (success).
[ci:skip-build] already built successfully in CI
Manual config changes:
* Enable SYSCON_REBOOT_MODE
* Enable LEDS_QCOM_LPG (not yet used but initial driver support present)
[ci:skip-build]: Already built successfully in CI.
For some reason kernel does not print anything to ttySAC3 even with
console=/dev/ttySAC3. If earlycon is specified it prints the early
stuff though.
Add ttySAC3 in both places anyways since that should be the correct
uart.
The riscv64 builder in Alpine is currently stuck, let's disable the
package for riscv64 temporarily so bpo isn't stuck on it for master. I
doubt anybody is using it on riscv64 currently.
[ci:skip-vercheck]
[ci:skip-build]: already built successfully in CI
