I unset CONFIG_ARM64_PTR_AUTH_KERNEL because the i.MX 8 CPU in the
Librem 5 doesn't support features from ARMv8.1-A and above anyway.
Same rationale applies to CONFIG_ARM64_TLB_RANGE being unset.
This gets rid of the Tux army on bootup. While it hurts my soul,
removing Tux from bootup makes it less flickery.
[ci:skip-build]: already built successfully in CI
Backport the Purism patch from https://source.puri.sm/Librem5/linux/-/merge_requests/640
"With this patch, older revisions (2.0) should be able to switch between
166MHz and 800MHz as opposed to being stuck to 800MHz all the time, since
that was the only supported frequency in the OPP table."
Signed-off-by: Alistair Francis <alistair@alistair23.me>
[ci:skip-build] already built successfully in CI
Remove the -dev subpackages of kernels that replace the linux-headers
package. As I understand, the only case where this would make sense is
if you wanted to build a kernel module against headers that need to be
newer than the headers in Alpine's linux-headers package (currently
5.19.5).
While this might have been historically relevant when wireguard wasn't
in the kernel and you might have needed newer linux-headers to build
the module, it seems irrelevant today. If somebody should need this in
the future, then bring it back properly / consider getting the
linux-headers package in Alpine upgraded. Right now the -dev packages
are broken in several ways:
* Use of unversioned provides= (pma#1766)
* Don't contain binaries needed to build binary packages (pma#462).
This was worked around in 6aba5f ("Package kernel-scripts
separately"), but later this didn't build anymore and we removed it.
So in short: broken and unused, drop them.
Replace usages of pmb:kconfigcheck-* options with
pmb:kconfigcheck-community which will be required for all devices in
community/main category. This ensures more consistent features &
behavior across devices.
Patches to work around modem instabilities are now in purism's fork, so
they were dropped.
I ran 'kconfig migrate' on the config, which is why there are a lot of
chnages there.
[ci:skip-build] already built successfully in CI
- Enable Broadcom and Marvel wifi drivers (cards exist that can be
installed in the L5)
- Add workaround that helps with modem disappearing when modem PM is
enabled. Doesn't solve it completely, but it makes the problem much
less frequent.
my patch to disable SS was merged in purism's tree, so it's dropped
here. This kernel also enables the hantro video decoding stuff.
[ci:skip-build] already built successfully in CI
Upstream changelog:
ca736e844a
Patches rebased, and includes some new fixes:
arm64-dts-imx8mq-librem5.dtsi-adjust-the-usdhc-bus-s.patch
- Being tested by Purism as well, has shown some promise improving GPS
reliability
arm64-dts-imx8mq-disable-SuperSpeed-instances-in-par.patch
- Fixes issue with modem disappearing
Upstream changelog:
4e76143d2e
Note, previous wifi driver behavior is not changed. The redpine module
still expects the fw to be in /lib/firmware on boot, and won't use the
fw on the card.. Theoretically this kernel version now supports both
loading fw from rootfs into ram AND using fw burned on the chip, but
since I haven't tested that well yet I'm leaving this as-is.
[ci:skip-build]: already built successfully in CI
Upstream changelog:
6dcba4b588
The redpine interrupt handler patch has been dropped since it's now
merged in Purism's tree.
[ci:skip-build]: already built successfully in CI
