Add the required dependencies and config for both hexagonrpcd and
libssc so that sensors start working.
[ci:skip-build]: already built successfully in CI
This cmdline argument is now a no-op. Drop it everywhere and add a new
CI check to enforce this.
Adjust the deprecated "minimal" initramfs variant to use
pmos.debug-shell to enable logging instead. It doesn't /support/
dropping to a shell, so the variable takes on a different meaning. But
that's ok since it's at least more consistent.
[ci:ignore-count]
[ci:skip-vercheck]
Signed-off-by: Caleb Connolly <caleb@postmarketos.org>
Tweaked-by: Oliver Smith <ollieparanoid@postmarketos.org>
[ci:skip-build]: kernel builds are very likely to go through now
Package was removed and is now included in boot-deploy.
[ci:ignore-count]: Lots of packages intentionally changed.
[ci:skip-build]: already built successfully in CI
Since audio over DisplayPort (over USB-C) is supported in the kernel,
add a UCM config to complete support.
To be clear, this might not work out of the box yet, I hope it'll start
working better when another audio route (speaker or microphone) is
working from kernel side.
[ci:skip-build]: Already built successfully in CI.
Since the GPU is supported since a while enable
deviceinfo_gpu_accelerated to let pmbootstrap show UIs like phosh.
Also with modem working with patched tqftpserv, we need the
msm-modem-uim-selection dependency, so add that as well.
* Add kernel modules for display to modules-initfs
* Add GPU firmware and dependency for Vulkan
* Add qbootctl to mark the current A/B slot as successful
* Add bootmac to set the Bluetooth MAC address on boot
[ci:skip-build]: already built successfully in CI
Without qcom,board-id and qcom,msm-id we need to use header version 2,
otherwise the device doesn't boot.
[ci:skip-build]: Already built successfully in CI
Add an initial port for the Fairphone 5 smartphone. This includes
firmware and close-to-mainline kernel package.
[ci:skip-build]: Already built successfully in CI
