pmaports/device/testing/device-pine64-pinephone/device-pine64-pinephone.post-install

#!/bin/sh

sed -i 's|#Name = BlueZ|Name = PINE64 PinePhone|' /etc/bluetooth/main.conf

rc-update add bluetooth default
rc-update add eg25 default
rc-update add gpsd default
rc-update add gpsd_pinephone default
rc-update add pinephone_setup-modem-audio default
device-pine-pinephone: new device (PINE64 PinePhone) (!583) * Added display in final pinephone to the kernel * Added getty * Use RGB led to signify booting status in u-boot * Enable CONFIG_GPIO_SYSFS [ci:skip-build]: won't finish in time 2019-08-28 13:57:48 +05:30			`#!/bin/sh`

device/device-pine64-pinephone: setup Bluetooth (!820) 2019-12-22 13:19:52 +01:00			`sed -i 's\|#Name = BlueZ\|Name = PINE64 PinePhone\|' /etc/bluetooth/main.conf`

			`rc-update add bluetooth default`
pine64-pinephone: start eg25 service at boot (!842) This should enable modem properly on the pinephone 2019-12-28 21:28:55 +05:30			`rc-update add eg25 default`
device-pine64-pinephone: Add GNSS/GPS configuration (!494) 2019-12-11 22:15:52 +01:00			`rc-update add gpsd default`
			`rc-update add gpsd_pinephone default`
pine64-pinephone: setup modem audio on first boot (!974) 2020-02-20 17:44:45 +01:00			`rc-update add pinephone_setup-modem-audio default`