linux-uconsole/include/linux/spi/sh_msiof.h

#ifndef __SPI_SH_MSIOF_H__
#define __SPI_SH_MSIOF_H__

struct sh_msiof_spi_info {
	int tx_fifo_override;
	int rx_fifo_override;
	u16 num_chipselect;
};

#endif /* __SPI_SH_MSIOF_H__ */
spi: SuperH MSIOF SPI Master driver V2 This patch is V2 of SPI Master support for the SuperH MSIOF. Full duplex, spi mode 0-3, active high cs, 3-wire and lsb first should all be supported, but the driver has so far only been tested with "mmc_spi". The MSIOF hardware comes with 32-bit FIFOs for receive and transmit, and this driver simply breaks the SPI messages into FIFO-sized chunks. The MSIOF hardware manages the pins for clock, receive and transmit (sck/miso/mosi), but the chip select pin is managed by software and must be configured as a regular GPIO pin by the board code. Performance wise there is still room for improvement, but on a Ecovec board with the built-in sh7724 MSIOF0 this driver gets Mini-sd read speeds of about half a megabyte per second. Future work include better clock setup and merging of 8-bit transfers into 32-bit words to reduce interrupt load and improve throughput. Signed-off-by: Magnus Damm <damm@opensource.se> Signed-off-by: Grant Likely <grant.likely@secretlab.ca> 2009-11-26 11:10:05 +00:00			`#ifndef __SPI_SH_MSIOF_H__`
			`#define __SPI_SH_MSIOF_H__`

			`struct sh_msiof_spi_info {`
			`int tx_fifo_override;`
			`int rx_fifo_override;`
			`u16 num_chipselect;`
			`};`

			`#endif /* __SPI_SH_MSIOF_H__ */`